Pfsense inter vlan routing5/26/2023 Setting up a new port group with a different VLAN, going through the same process as above.What do I need to do to allow this router on a stick setup to work? I've done all sorts of troubleshooting, I don't have the ability to do a packet capture anywhere to see what the issue is, so I'm hoping this is some small oversight I forgot to check. Oddly enough, setting up a DHCP server on the VLAN interface lets my ESXi host pull an IP. I cannot get my ESXi host to ping the default gateway of 192.168.10.1, and I can't ping the ESX host from the default gateway. I made sure the trunks were state active. Ouch On another VLAN, I cant access the WebUI of my FreePBX server. On one VLAN, I cant access a WebUI running on HTTPS. On the Cisco switch, I made the switchport to the ESXi Host and to pfSense both trunks, and allowed VLAN 1 (Native) and VLAN 10. Hi guys So, I put together my fifth or so pfSense box, put in the regular rules, setup the usual Intel GBe (igb in this case) tunables, setup gateway based routing, and Im done Or so I thought. I gave my ESXi Host an IP of 192.168.10.10/24 and made the sure the Management Network Port Group was using VLAN 10 tagging. I enabled the VLAN interface in pfSense and gave it an IP address of 192.168.10.1/24. I created a VLAN (VLAN 10) in pfSense using my LAN interface that goes back to the switch (a Cisco 3750). ![]() I have the following set up:ĮSXi Host -> Switch -> pfSense Router -> Internet
0 Comments
Leave a Reply. |